Air Volume Valve Spacer [Crossover]

For play requiring lower velocity settings, it may be necessary to utilize the Air Volume Spacer included with the Crossover.

To install:

1) Follow Unloading Your Marker on page 10 and Air/CO2 Cylinder Removal instructions on page 16 of your Crossover Manual.

2) Loosen and unscrew rear end cap and air valve assembly.

3) Snap Air Volume Valve Spacer securely onto shaft of air valve (Valve End Cap).

4) Reassemble rear end cap and air valve assembly into receiver.

5) Adjust regulator pressure to achieve desired velocity.

Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.