Barrels for the U.S Army Guns [Alpha Black, Bravo One, Carver One, Tango One, Project Salvo, Sierra One]

The US Army line of guns, including the Alpha Black / Bravo One, Project Salvo / Sierra One, and the Carver One / Tango One use Tippmann 98 Thread Barrels.
To fit in the shrouds, the barrels must meet some requirements:
  • US Army Alpha Black & Bravo One - 9 inch Minimum Length x 1 inch Maximum Diameter
  • US Army Project Salvo & Sierra One - 9 inch Minimum Length x 1 inch Maximum Diameter
  • US Army Carver One & Tango One - 4.5 inch  Minimum Length x 1 inch Maximum Diameter
Most barrel diameters are less than 1 inch.  To compensate for smaller barrels that fit inside the shroud, you may need to add a shim for a tight fit.  This can easily be done with a few wraps of electrical tape (a paintball players best friend).  Add where the front of the shroud is going to meet the barrel when it is fully installed.

Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.